Good recommendations

…make a surface gauge. In the block of hard wood drilled a hole in which is screwed into the screw. Use a screwdriver to set the distance required for the application of risks.   V. MERDIS, Moscow

Using just two wooden bars, metal bars, vise and elastic steel wire, we can quickly produce the spring. Its length depends on the number of turns around the rod, operated by a bunch of wooden beams, between which is passed the free end of the wire.

Before painting the ceiling during the repair of the apartment it is usually carefully cleaned of previous coatings, and all around, usually covered that off. To avoid unnecessary dirt succeed, if work brushed metal with a rubber trim around the edges and a hole in the middle for connection with a pipe cleaner.

For lovers of flowers is always a problem to cut the tender shoot, not damaging it. Neither the knife or household scissors, or the more secateur is not able to perform it in a way that didn’t shatter or wrinkle soft stem plants. However, if you shorten the usual stationery scissors and carefully applied to Read more…

It is known that under the influence of moisture flat sheets of paper or cardboard several diverging and begin to warp. This quality can be used for production at home is simple device, clear from the picture. Strip of Kraft paper (used generally for packaging of goods),mounted on a rack connected with the arrow pointing Read more…

Toothbrush and a light plastic Cup for rinsing would not be thrown on country sink, if to do here such expromstroy suspension, as shown in the figure. This light combo bracket is easy to fabricate in a couple of minutes of thick soft wire, folded in half. In the upper part of the curved semi-circle Read more…

The easiest and most common method of fastening a wooden handle in the head any hand tool — a wedge. Over time, however, and such fastening is weakened, shaken. To avoid this, I propose to use the same wooden wedge, but to be sure you lubricate it with epoxy glue. The remaining spaces in the Read more…

If the hand is a metal sheet or scrap plywood, enter them between the fork tines – get a good shovel.      

The shades for the chandeliers or lamps are so narrow that screw in a light bulb, and if necessary, remove the ceiling — the hand crawls inside to remove the plastic retaining nut cover. Make it allows… wooden Laundry tongs, as shown in the figure.

Quick coupling by means of a bolt and wing nut is highly popular among the homebrew. Unfortunately, you can buy nuts anywhere. We offer you a “lamb” simplified design is for everyone. This will require a steel or dural profile”area”. The width and the thickness of its shelves are selected depending on the diameter of Read more…