When connecting parts of the piping or hydraulic system, connect the tool to the pneumatic system or an irrigation hose at the joints not to do without special connector — threaded couplings, a special cartridge or fitting. If this site cornersburg, the traditional ways of connection often does not justify itself: they, as a rule, laborious and slow.
Central to the exhibition NTTM-78 the young army innovators revealed a new method of joining tubular elements of the castle. They have developed the design of the connecting node does not have threads, complicated adapters and other inconvenient to use parts. The whole docking station is composed of three parts: the actual tubular elements and snap ring.
At one end of the tube grinds to a cone ring nut that allows you to enter it inside the second element, the outer tube is the inner groove, and the internal — external with a jumper wire, it stops.
Joint — lock for tubes:
1 — outer tube element 2 — internal, 3, 5 — ring grooves, 4 — ring-spring-retainer, 6 — blank, 7 — conical lead-in section; And — the junction with the countersunk head focusing.
To connect both parts, first from the inside, insert a split snap ring. Upon reaching the groove, it sinks into her, securely linking structure. Separation is effected by mutual rotation of the elements. The ring expands, leaving a groove, and the pipe is released.
In another embodiment, connector Assembly, the emphasis is movable and can utaplivajutsja through a special hole in the outer element. This allows you to maintain mobility of the joints.
Recommend to read
INSTEAD OF BATTERIES
This miniature power pack sits in the battery compartment handheld radios, calculators and other miniature electronic equipment where they need to be connected to AC power. After...
RELAY-THE DEFENDER
Modern charger (storage) and power supply units (PSUs) are equipped, as a rule, electronic protection against short-circuit (SC) output. However, in Amateur practice and meet simple...
