Advice

Toothbrush and a light plastic Cup for rinsing would not be thrown on country sink, if to do here such expromstroy suspension, as shown in the figure. This light combo bracket is easy to fabricate in a couple of minutes of thick soft wire, folded in half. In the upper part of the curved semi-circle Read more…

The easiest and most common method of fastening a wooden handle in the head any hand tool — a wedge. Over time, however, and such fastening is weakened, shaken. To avoid this, I propose to use the same wooden wedge, but to be sure you lubricate it with epoxy glue. The remaining spaces in the Read more…

If the hand is a metal sheet or scrap plywood, enter them between the fork tines – get a good shovel.      

The shades for the chandeliers or lamps are so narrow that screw in a light bulb, and if necessary, remove the ceiling — the hand crawls inside to remove the plastic retaining nut cover. Make it allows… wooden Laundry tongs, as shown in the figure.

Quick coupling by means of a bolt and wing nut is highly popular among the homebrew. Unfortunately, you can buy nuts anywhere. We offer you a “lamb” simplified design is for everyone. This will require a steel or dural profile”area”. The width and the thickness of its shelves are selected depending on the diameter of Read more…

Undoubtedly, the plastic siphon for washbasin much better than cast iron. But the trouble is that they are not interchangeable. Throwing worn-out iron and putting plastic, we have something to fill the annular gap, as each of the pipe under the old syphon has an internal Ø 72 mm, and outer diameter of plastic pipe Read more…

Driving in the ground stake (for example, for the fence), usually using sledgehammers. But it’s okay if the count is not above your height. Otherwise have to fence any stand, install the ladder. If you have nothing at hand to help out here is a simple fixture: coke strapped to the wooden wedge. Here the Read more…

…is necessary for anyone who makes anything out of metal. But where to take it? Turns out it can be made from a piece of old rail. It is enough to cut autogenous cutting unwanted parts, adding the procurement of the required form, and get to work.