If you pin, as shown in the illustration, a conventional hammer with a thin layer of polyurethane or of thick rawhide, it becomes possible to use it during the Assembly of panel furniture, metal works – in short, where the damage to the surface is extremely undesirable.
Recommend to read
THE BENCH IN THE HALLWAY
MATERIAL: metal rod Ø 4 and 5 mm, cut sheet metal with a thickness of 2 mm, Board thickness 18 mm three-layer plywood, bolts М3Х20 mm, glue for wood, colorless furniture varnish, primer...
“CUTTER” IN JUST A FEW MINUTES
I made a root vegetable chopper, so necessary for providing home livestock with vitamin feed ("chopped feed"), based on a decommissioned ATD2—a disc fertilizer spreader that I managed to...
