In cases where there is a need to support the work piece in the vise so that its upper face is parallel to their lips, you will help offer a simple fixture. It consists of two identical right-angled triangles cut out of sheet aluminum. The first is mounted on the sled clutches; it is attached to two bent area of focus for sustainability. The second has a handle for convenience and two plates, limiters, not giving to slide off the bottom of the triangle. To use the device should be so. Install the lower angle on the thread that the clamp a workpiece, slide the top angle and moving it along the bottom, move to the workpiece from below. Then lightly spread your lips Ki vise to the workpiece is freely rests on the horizontal side of the polygon, and finally hold it. V. SLAVUTA, To IEV
Recommend to read
SLED WITH A PROPELLER
This town is located in the Perm region. Called Tchaikovsky. In summer lives of ordinary working life. With the onset of winter is starting to sound a special music. It does not arise...
LAMP “BOOK”
Sitting down at the table to work, you take from the shelf a thick book and open it. But what is it? She turns into... a small lamp! It turns out that the book cover hides a cartridge...
