Even with a good glass cutter is not always exactly separated cut piece of glass. However, if along the barely noticeable risks left by the carbide roller tool to make the tape wet paper — the traditional tapping on the glass it will fall strictly on the cut line.
Recommend to read
DRILL PIPE…
When I need to drill a hole in glass, I use this way. In the Chuck of the drilling machine is clamped copper tube length of 100 mm (the diameter is adjusted depending on what you need...
KMD-CHANGELING
The design of the rear cover of the engine KMD-2,5-made, in our opinion, wrong. The flow of fresh fuel mixture from the distribution node goes directly to the bypass channels of the...
