Of tubes of different diameter, tightly placed one on another, you can build a jig for drilling end holes in cylindrical rods of various cross sections. For the outer bushings are better to use a steel tube with a thickness of 0.5 mm, and the inner insert can be bent any sheet metal. V. MARTINTON, Novocheboksarsk
Recommend to read
“NEPROLIVAJKU” FOR PAINT
The simplest "neprolivajku" for the paint or varnish can be done EA literally two minutes, if you drive in a Board cut two nails and pull them rubber ring cut from a Bicycle or a car camera.
Build trailers!
Quite recently, trailers for passenger cars appeared on the roads of our country. This new vehicle very quickly gained the widest popularity, and during vacation periods on highways one...
