Recoiling the rope from multiple cords by using a simple device. In a wooden bar size 400x60x30 mm drill at a distance of 140 mm from each other three-hole Ø 6 mm. they put In the collars, curved-steel wire Ø 6 mm also, and sticking the ends to form a round nose ring. Arms connect the sync wire link. To the collars are not stuck, but the link did not come off, put on arm and fix the two compression nuts of the limiter. The rope recoil. Rings to tie ropes required thickness and length. One person drives the average gate, and the other pulls the rope obtained by intercepting it as it is spun. S. CHISTYAKOV, farm Seleznev, the Rostov region.
Recommend to read
With a trailer on a Niva
The favorite car in the countryside is, without doubt, the full-wheel-drive, high-clearance VAZ 2121 “Niva”. Unfortunately, our industry does not produce trailers specifically for this...
SINCE THE BUBBLE IS UNDER THE LINE
I think that many readers are not only sawing and plowing, but also relax with a fishing rod. When winding leads (loop the loop) on motoviltse on the line stay sharp bends. I propose to...
