All good traditional marking gauge. Its only drawback is that after marking the workpiece on its surface still scratches. If you make the tool, shown in the figure, on one side of the pin you can pin the needle in with the other paste pencil lead.
Recommend to read
THE PATCH ON THE CYLINDER
To mark the holes located at certain angles on cylindrical parts without special tool depot is quite complicated. To help out in this situation will a strip of adhesive plaster or tape,...
IT’S CALLED “APC”
Amateur constructor Oleg Alievich Starikov from the Moscow region village of Ostrovtsy is known to many thanks to his handsome jeep "SIMOT", built in 1996. This car could be seen on the...
