Many items of furniture, housings of radio equipment, various devices are connected on cylindrical spikes Ø 6-8 mm of hardwood (usually oak or letters). Make them the traditional way, obstruguy sticks to a circular cross-section — time-consuming. Prepare some small strips of square cross section with sides approximately equal to the diameter of future spikes. Then pick up a nut of the correct size and install it on supports (e.g., jaws), as shown in the figure. When you click on the rack to thread the nuts will chip izbicki and work spikes are strictly of the same diameter. V. VASELIN, Krivoy Rog
Recommend to read
PROTEINS ON THE SHELVES…
When books on a shelf a bit—they are unstable and fall. And folded stack of inconvenient to use: we need not so easy to remove from underneath lying on top. It is therefore desirable to...
CUT… BEARING
Not find, perhaps, a car or complicated mechanism which isn't used ball bearings: they are embedded in devices and engines, airplanes, and tractors, bringing accuracy, reliability and...
