For the lubrication of parts in hard to reach areas convenient to use the oiler is made of end of life rod of a ballpoint pen. It can be done in a few minutes. To this end, the tweezers remove burner Assembly from it with a needle, squeeze the ball. Then rinse the site with a plastic tube with Cologne and re-assemble them. Hard wire wrap thread to form a piston, which would include a tube with little effort. The free end is better to bend into a ring for convenience when filling oiler. A. SHVETSOV, the town of Malgobek
Recommend to read
Selling scooters and mopeds rental
Buy a scooter, even despite the fact that these machines are mostly measured not so expensive, especially in the secondary market is an important event, and not even because in any case,...
CORD PROTECTION
Cord electric soldering iron is typically not heat-resistant insulation. Therefore at its hit on a hot tip, perhaps a quick melt insulation and short circuit of wires. To avoid this, it...
