WILL NOT SLIP OFF

WON'T SLIPIn the processing plane of the edges of the wooden parts is difficult to adjust so that the tool cannot slip sideways and did not spoil the work.

However, the output is very simple: you need at least one side of the plane to squeeze the clamp a short scrap boards — it will reliably hold the tool on the edge.

Recommend to read

  • NOT TO THE SIDE AND UPNOT TO THE SIDE AND UP
    We are accustomed to the fact that the curtains should be spread out. For this there are special rods or strings, fastened above the window. Some of them are mechanized: it is necessary...
  • A SOLDERING IRON WITH A NEEDLEA SOLDERING IRON WITH A NEEDLE
    To unsolder chips from a PCB — troublesome. However, it is simpler if we use a medical needle, a sharp tip which is pre-cut with a needle file or abrasive block.   O. I, Voronezh