Advice

Of tubes of different diameter, tightly placed one on another, you can build a jig for drilling end holes in cylindrical rods of various cross sections. For the outer bushings are better to use a steel tube with a thickness of 0.5 mm, and the inner insert can be bent any sheet metal.   V. Read more…

If you have a few small flat brushes, and painting works took fleyts, you can do it yourself. Take two flat brushes, and connect them firmly clamped between two plates of plywood and knocking small nails.

When nastilanie of the sexes the hardest thing is to lay the last Board — not so easy to “drive” it in the remaining slot. Moreover, the width of the gap sometimes lack some few millimeters. How to move the already laid boards, especially if you hit them with a hammer prevents the wall? In Read more…

Not so easy to prepare items large drachevym file. Most often, the difficulty lies in the fact that such a large tool is uncomfortable to hold only right hand and only press the top left — need a second handle. Hastily it is possible to make a standard clamp, if you secure it to the Read more…

Painters love to tell stories about the master, who, fascinated by the coloring of the floor along the walls, not noticed as it stained everything around him and was unpainted on a small island in the middle of the room. But when laying tiles it is better to start with the middle of the room, Read more…

Sometimes screws can be found one unpleasant defect — too deep a slot screwdriver. While trying to Unscrew a screw half of the cap often breaks off. How to be here? One of the possible paths shown in the figure. Press down firmly on the screwdriver to any object that serves as a lock — Read more…

Work bench at home — an unattainable dream for many craftsmen, therefore, frequently suffer from the usual tables. However, any counter top will remain intact, if to make for her this patch. For such microvertical suitable cut sheet of chipboard to which one end of the top and bottom are nailed on the other, and Read more…