For six years, regularly serves me scooter “Tourist”. For movement on muddy or snow-covered road made to replace the rear wheel other — terrain. In old tires drilled on either side of the treadmill two rows of holes Ø 5 mm (they are located around the circumference in pairs at a distance of 50 mm from each other at intervals of 160 mm). Dragged through them like snake steel cable Ø 6 mm, pre-dumping ends by electric welding. Put into the tire is cut on the inner diameter of the chamber, and it is working and mounted the wheel, align the ends of the rope over the edge of the disk.
V. LAZUTA. Kuibyshev
Recommend to read
SHEET CONDUCTOR
When you need to hammer a nail near the ledge of the wooden parts, then there is always the danger of damaging it. However, this will not happen if you use any metal or plastic strip...
FLOATING WITH A CAR
It's good to live on the bank of a wide, full-flowing river! True, this convenient transport artery often becomes an annoying obstacle to communication between settlements. A motorist...
