Chips, widely used in the electronics industry, are increasingly used in Amateur practice. However, when itike them in charge or replacement from the wizard, you need increased accuracy, and loyal companion of tweezers, it turns out it is not enough convenient: along case the ICJ did not seize, but backwards can damage the contacts. Here and useful simple clamp made from wooden clothespins. On each of its jaws with a screw with a M3 nut to fasten the wire braces, the dimensions of which are selected exactly according to the dimensions of the integrated circuit. Now the work will go faster and risk damage to the parts during Assembly will decrease.
Recommend to read
The CHROME plating? NO PROBLEM!
To perform work on the cylinder liner is made mandrel. Its structure is clear from the figure, we focus only on certain details. The anode — steel stud; one end over a length of...
CONSOLE FOR LITTLE
Was "from a pot two inches", but here grew the baby becomes independent, although the adult toilet yet still too big for him yet. I advise you to make from plywood and boards here's a...
