Cord electric soldering iron is typically not heat-resistant insulation. Therefore at its hit on a hot tip, perhaps a quick melt insulation and short circuit of wires. To avoid this, it is necessary to wear a cord round the required number of ceramic insulators that are used in the irons and frying cabinets. Plug contemporary electric soldering iron in most cases, non-separable, so it should be removed and strung on the cord insulators, mounted on the end of wires modular plug.
Recommend to read
REPAIR IT YOURSELF!
A small speck of rust on the wing in a few weeks darkened, and then turned into a hole with ragged edges. Avtostantsii the sentence was harsh - the wing needs to be changed. Preliminary...
WILL WARM AND COOK THE BIOGAS
Biogas. Used in Ancient China, and then millennia later, once again "open" as "non-traditional, environmentally friendly energy source of the XXI century", it attracts a growing attention...
