To make the Board a groove type “dovetail” is not difficult. Two cut with a hacksaw, one blow chisels and groove ready. When processing the same chipboard or plywood such technology is unacceptable because of the relative homogeneity of the material in two or even in three directions; the chisel will not help — sawn tongue not break away. Therefore, it is better to use a jigsaw with curved approximately at 45° the ends of the machine. Such a tool can be cut even by the pine, carried out along the boards, a jigsaw is not available.
Recommend to read
FROM BIPLANE TO MONOPLANE
Carrier-based scout CURTISS SB2C HELLDIVER. In early 1938, the Bureau of Aeronautics of the U.S. Navy has developed the conditions of tender for the construction of a new deck of...
GLIDING CAR…
Curious views accompany this anipa everywhere. And no wonder — too unusual looks drown it in the car... a boat on wheels. We are talking about a vehicle that exists so far in a single...
