Often in the manufacture or repair of furniture made of particleboard require dowels of circular cross section. Manually with a knife to whittle them long, and the diameter of turns of equal length. I propose to make dowels from wooden slats, for example, a cross section of 9×9 mm punch cuts a hammer through a hole with a diameter of 9 mm in a metal plate of thickness not less than 10 mm. Preferred material for dowels pine slats. A. SHEVTSOV, Kaguya
Recommend to read
THE HEATER IS A SOLDERING IRON
Usually wings models air combat and cord upholstered Mylar film. Stick it to the frame using BF-2, and the joints are heated with a soldering iron with a special nishikoi. In the Studio...
POURED “ON THE NECK”
Some plastic and metal containers — cans — sloping neckline. Of them conveniently pour out contents, and in this sense, the design, of course, justified. Also said to fill the canister...
