One arm movement — and in an unusual vise clamped firmly from two shafts, the diameter of which can reach up to 120 mm. the Design of this hot clip is rather simple, based on it — four prisms, pnevmotsitami and clamp. Works device is isolated. Compressed air through the check valve, which prevents the clamp from camerascreen when the pressure of air on the network. Moreover, the operating pressure is maintained in the cavity of the cylinder for a time sufficient for its completion.
“Double” clip:
1 — base, 2 — prism, 3 — clamp, 4 — bracket clamp, 5 — pnevmotsitami, 6 — control lever.
The fixture allows you to drill holes in ends of shafts in radial drilling machine, to which it is attached to one side of his Desk.
The application of this simple device makes it possible not only to mechanize the manual operations, but almost a third to raise productivity.
Recommend to read
LuAZ-969М
Serial production of the new car called ZAZ-969В began in 1966 in Lutsk machine building plant (1967 — Lutsk automobile plant). The car was designed in KB of Zaporozhye automobile...
THE PAN — SPOUT
Good aluminum pot is lightweight, inexpensive, milk by boiling in it does not burn. Only trouble is: pour out a small portion of it - a problem that will definitely spill if the edge has...
