Before you drill cylindrical in shape, its surface need to procure under the drill “the hole” — to stake. But not so easy to set the core to such detail. Helps may this simple device, consisting” of two halves: the bottom serves as bed for the most part, and on top of the guide pins worn shaped clamp with holes for the core. It is much easier to work, improves the accuracy of markup. The fixture will stand in good stead not only at home but also at work. N. PASHCHENKO, Turner, Donetsk region.
Recommend to read
“DIMENSIONLESS” ROD
If in a ballpoint pen out of toothpaste, and long rods at hand was not, take the short splice and its extension from the part used stem, cut off from the writing site. To the working rod...
WOOD ENGINEERING
Say, in the Urals during the difficult years of chaos after the civil war an artificer built a car where everything was wooden, even the engine. However, if the wizard so the echo...
