SCREW TIGHTLY

SCREW IN TIGHTLYIn cases when you want to prevent turning of the screw, screwed into a Board or plywood, I use a very simple way. Of stiff wire or a nail, whose diameter corresponds to the width of the slot of the screw, hollow out a U-shaped bracket and pin it as shown in the figure. Upon entering the slot, it securely holds the screw.

 
S. DUBINSKY, Kiev

Recommend to read

  • “HOME DRILLING RIG”“HOME DRILLING RIG”
    Having a plot of land for a vegetable garden in our climate zone, regular watering is necessary to get a good harvest. But in the absence of your own water well or a well, at the...
  • Rare box of useRare box of use
    Chetyrehmillimetrovoy Small sheet of plywood, 10 mm thick plate, nails or screws: all this is enough to make an extra drawer in the kitchen table with a folding cover. It is possible to...