THE GROOVE HELPS TO BEND

GROOVE HELPS TO BENDProcurement of thick sheet metal (3 mm and above) to bend at home will be easier if bend line is pre – “grinder” to make an incision to a depth of at least half a millimeter.
 
A. MATVEICHUK, Zavodoukovsk, Tyumen region.

Recommend to read

  • TOUGH CHOICETOUGH CHOICE
    Executive car AUDI A8 L 6,0 QUATTRO. It is difficult to make a choice between the "Klin" and "Zhigulevskoe" beer; it is even more difficult between firms computers "Macintosh" and...
  • SCHOOL OF AIRCRAFT (PART 4)SCHOOL OF AIRCRAFT (PART 4)
    AIRPLANE FOR TWO. Use of a low powered engine in a two-seater suggests several options of its aerodynamic layout. If not enough power, you can increase the load-bearing properties of the...