THREAD NUT

THREAD-NUTYou need to cut into the rod thread. Dice you have, but no holder. How to be? Very simple. Choose a nut, which enters the die is tight, with no gap. Saw the thread and nut groove, align it with the similar groove of the die and hammered into the hole the pin slightly asclepia it. The thus obtained holder attach to a corresponding wrench, the workpiece clamp in a vise. Further operations are no different from the usual.
 
N. TSARAPKIN, Tashkent

Recommend to read

  • THE BEST PROPELLER FOR YOUR MODELTHE BEST PROPELLER FOR YOUR MODEL
    Now, when the rules of the FAI, the weight of the rubber motor is reduced, and the number of rounds in the competition increased to seven, rotor group should be given maximum attention....
  • “FIREFLY”“FIREFLY”
    This simple and reliable model was developed in the Chisinau children's club "Firefly" under the leadership of Alexander Pavlovich Marchenko. All modelers-beginners, writes...