A shovel with a horizontal handle to work much easier, but do not buy the pen new, and normal when the shovel is easy to equip the same. To make it possible in just a few minutes. This will require a section of steel pipe with a length of about 200 mm with an inner diameter of the shovel handle, wooden handle and a few screws. With a hacksaw cut the pipe end two longitudinal cutting length of 120 mm. Two opposite “petals” of the drilled or cut with a chisel, and the remaining bent as shown in the figure. It now remains to drill holes for screws to mount the horizontal arm and the handle on the handle, and prior to Assembly rounded edges and paint.
N. SIDOROV
Recommend to read
ETERNAL MICROVENTILATION
The ventilation needs of many suburban buildings. Without it, mold in houses and sheds, get wet cellars and basements, and only use luftblasen, where there is no fan, to put it mildly,...
Muffler — a not simple device
Interest in homemade mufflers is driven primarily by the unsatisfactory quality of series products. It is quite natural for an amateur designer to want to improve the parameters of their...
