The hole in the metal plate can be obtained without drill: it is enough to bend it and work a round file or a needle file. This technique is especially useful when you want an oval hole. It is applicable for punching a rectangular window or a narrow slit: in this case, use is not round, but flat needle file or hacksaw.
Recommend to read
THE BOOT FOR ANY SEASON
When developing this design car trunk, the task was to create a device which, in addition to the normal daily functions would satisfy and lover of outdoor activities — would allow us to...
“SERVING” TABLE
If you take the end-of-century baby carriage and clamped on a plywood panel with holes and shelves, you can get a very comfortable truck to embed a whole set of tools to take care of a...
