Often in the repair of threaded holes used hand tools — tap for mounting which uses a special tool holder — handle, and each diameter requires its own hardware. Young innovators Kyiv repair and mechanical plant has developed and introduced the universal knob. It is suitable for taps of various diameters — with squares from 5 to 15 mm. Feature of the device in that the clamping plate has a movable biscuit, freely connected with a threaded handle. Rotating it, you can increase or decrease the clamping hole by the movable rusk, holding the tap.
Universal tap wrench:
1 — threaded grip, 2 — clamp clip, 3 — medium dry, 4 — stationary biscuit, 5 — tap.
Recommend to read
ORBIT ON “SOYUZ” — “APOLLO”
And again start. The same, now familiar sequence of events. A meeting of the State Commission, which approved the crew. The meeting on the launch pad, the report of astronauts before...
TRIANGULAR STOOL
In the apartments of mass developments of the past years of food is very petite in every square decimeter. In these areas put only the furniture, without which one cannot do. And if the...
