We offer to your attention a simple device with which a lathe can cut the worm wheel with any number of teeth. As the cutting tool used here is the standard tap mounted in the Chuck of the machine and pre-loaded tailstock. The fixture is a mandrel, mounted in the tool holder. Harvesting worm wheel is pivotally fixed to the mandrel and is fed to the rotating the tap; he cuts into the workpiece and begin to penetrate the grooves, at the same time turning the future of the worm wheel. A few turns and can be removed from the machine the finished part.
Recommend to read
ON-BOARD NETWORK UNDER CONTROL
I offer a homemade device allows you to control voltage vehicle electrical system. In particular, that's all right — the battery is charged and generates the required 12-14,8 V, the signal...
“PRESS” FOR TUBE
This simple device facilitates the use of any tube, helping to squeeze it evenly and gently. It consists of a base in a hole which is inserted the tube, and turning a key with slit for...
