The heel of any Shoe wears out the fastest. To replace the erased printing is a snap. Especially if the body of the heel solid. Then a piece of corrugated rubber, you can just stick a rubber or special Shoe glue, or at least beat carnations or pin braces with a carpenter’s stapler.
Worse when the heel — with removable replaceable heel cap. Because replacement new is not always available, and the other, random, may not be suitable because the landing slots may not correspond to the mounting pins of the “foreign” heels.
However, there is a solution, and quite simple. Regular printing is not required, be appended again a piece of corrugated rubber or plastic. For this purpose, the contour of the heel is first redrawn on paper, and it is then pierced holes corresponding to the landing jacks of the heel. Now for this “pattern” can only cut a replacement.
However, you should prepare and heel. Landing in his nest trying to drive carefully … suitable plastic dowels (in the extreme case, you can insert and wooden plugs). Then the blend is prepared heeltap superposed spaced holes with mounting slots, and carefully screwed in the screws. The heel — like new!
Recommend to read
EXACTLY IN THE RING
When sawing any, but in particular plastic pipes (due to its "softness") to withstand the cutting line is exactly perpendicular to the axis (or if necessary - on the contrary, under the...
THE ELECTRIC CAR OF FORMULA D
No matter how much we have seen this picture every time it will amaze and fascinate with their uniqueness: easy flick of a switch — and just as silently as it stood, the car started and...
