…AND WITH THE WIND AT FULL SAIL!

...AND THE WIND AT FULL SAIL!Wish to give modelers another way to give the sail models naturally convex shape. This method is simple, but perhaps more effective than others. Its essence is as follows.
Prepared by Parus moistened in a solution of starch, and then using the buttons is hung on the rail of the foot, which will gain a foothold on the mast, the forestay or ray model. Sheet corners are respectively true position on the model.
 
 
If you have “quit” several sails, make a frame like the one shown in the figure.
 
Carefully straightened the sail obuwie his jet of air from a vacuum cleaner. Within a few minutes the sail to dry, while retaining a convex shape.
 
A. zhigal’skii, Leningrad

Recommend to read

  • TO REMOVE THE RING — WEAR RINGTO REMOVE THE RING — WEAR RING
    It's hard to say which is harder: to put on or take off hard a spring ring serving as a seal between the walls of piston and cylinder internal combustion engines, compressors, pumps,...
  • CURLING WALL SCONCECURLING WALL SCONCE
    The shades for the chandeliers or lamps are so narrow that screw in a light bulb, and if necessary, remove the ceiling — the hand crawls inside to remove the plastic retaining nut cover....