THE WATERLINE FROM THE FILM STRIP

WATERLINE FROM THE FILM STRIPNovice constructor of ship models at first it is difficult to apply ka ha! ship or vessel clear and beautiful the water line. This task can be greatly simplified by using the method used in ship modeling circle Kaspiysk. First of all you need an old film. Clean her up from the emulsion with warm water, Pat dry and apply a spray the nitro of the desired color. When it dries, cut the film into strips. It remains to glue them Amalita to the body coloured side by side model. “Recapture” of the waterline and can be on the finally trimmed model, but in this case, the film will protrude above its surface. Better to stick the film on the case, prepared for painting. After final finishing and sanding with fine waterproof sandpaper it will be flush with the top layer of paint.

Recommend to read

  • DRILL-BABYDRILL-BABY
    The construction of any model is unthinkable without cutting in detail dozens of holes in the first place is quite small, with a diameter of less than 1 mm. you Buy such a drill, of...
  • THE THERMOSTAT OF THE IRONTHE THERMOSTAT OF THE IRON
    With great interest I read in "M-To" article L. Christmas "Cellar, on the balcony." Without a doubt, the invented by good and necessary in a city apartment unit. Writing about the atom...