Advice

If you cut the old metal pipe of large diameter to be sawn along, and then riveted with their convex sides to each other, get both and convenient stand for pens, brushes, pens, and heavy-duty clamp, easily holding even the old electric roller blind.

Neat woman, always worried if the cooker escapes milk or zarazhayutsya fat burners from the naked red-hot pans. Moreover, the penetration is not so easy to clean. A small trick will save the neat from these experiences: it is necessary to make sheet metal patch discs on burners. Even if something escapes from the pots Read more…

To straighten dents on the tin, usually use a rubber or plastic mallet, because metal drummer would leave sunken footprints in the soft material. If mallet is not at hand — you can use an ordinary hammer, but that he was “delicate”, the striker should put the rubber cap such as wheelchairs canes.

Motorists have appreciated a commercially available foot-pump to inflate tyres equipped with pressure gauge: it is easy to use and allows you to constantly monitor the pressure in the chamber. But the pump is the old type with the help of simple consoles can be equipped with a pressure gauge. This would require a metal Read more…

My way of fastening several sheets of paper, especially with a tight cover or tab, affordable, fast and reliable, so that will help out students or students who have to apply for different papers. Invested in in half, bend the “cover” of paper pages don’t have to glue or sew. It is sufficient to enclose Read more…

Convenient storage of small tools is not only about safety and effectiveness. I think that drills, taps, needles, and other small tool is best stored upright in a plate of thick rubber. Perforations drilled or punched with a sharpened pipe, and their diameters must be smaller than the diameters of the installed items by 30 Read more…

If the rune was not polishing — no problem! With the processing of small surfaces perfectly cope conventional tube driven in rotation by microdrill. To secure the tool cartridge in probnu 3/4 of its length you should install the screw and then cut off his head. Before polishing the tube should be rubbed with the Read more…

Chips, widely used in the electronics industry, are increasingly used in Amateur practice. However, when itike them in charge or replacement from the wizard, you need increased accuracy, and loyal companion of tweezers, it turns out it is not enough convenient: along case the ICJ did not seize, but backwards can damage the contacts. Here Read more…

A thin drawing pen tool is fragile, and inserted in a normal pen, easily spoiled by careless storage. Better to use it with the handle, and with a collet Chuck: and is held securely, and, turning, to store this safely.