A wonderful sander is obtained from the drill, you only need to equip it with a set of abrasive tools. Some of them are easy to make yourself. In particular, to make a cylindrical abrasive, you will need a wooden drum of suitable size and steel stud M8, fixed it using p^ry nuts. Well, in order to secure the tool skins, the drum is drilled a hole with a diameter of 10 mm and is cut, as shown in the figure. Fixing the skins of the drums— using fixtures consisting of rubber tubing, through which is threaded a long bolt with a nut.
Recommend to read
UPGRADE SCREWDRIVER
The tightening of a screw into a solid material gives a lot of trouble. Enough only slightly to tilt the screwdriver as that breaks down, sometimes cutting slot of the screw. To avoid...
CAN CUT, GRIND AND CUT
(The end. Start at # 1’04) Power bracket (Fig. 7) is welded in the form polukrovka of steel sheets of different thickness. At its rear side is located, as already mentioned, the...
