To install the ball bearing in the workplace, it is necessary to produce it under the special case that is often associated with certain difficulties. Here is one simplified but reliable solutions to this problem. It is necessary to produce the plate-base with threaded holes and a triangular groove is slightly less than the diameter of the bearing, install bearing and cover it with another plate with mating groove, pulling her to the ground with two bolts.
Recommend to read
DINGHY “SALUTE”
Rigging centerboard yacht "salute" consists of two sails (mainsail and headsail), mast, standing and running rigging. Mast are called wooden parts of weapons ("Salute" sail type "Guara"...
TRAINING AIRCRAFT UT-1
TRAINING AIRCRAFT UT-1. Scale model 1:33. UT-1 (air-14) - small size (wing area only 8.3 m2) training single pilot with the airplane had an open cockpit. The plane was created as a...
