Good aluminum pot is lightweight, inexpensive, milk by boiling in it does not burn. Only trouble is: pour out a small portion of it – a problem that will definitely spill if the edge has no flanging. To rectify the situation is very simple. Make a well in the hollow plate, place it on the edge of the pan, and the inside on the hollow – steel rod and hit it with a hammer and make a dent. This “nose” will gently leak out of the pan any portions. Not only need to get involved in the size of the “nose” so it does not protrude from under the lid of the pan. You can do it without tablets, if use instead a sheet of soft rubber (no slits) with a minimum thickness of 10 mm.
Recommend to read
A SUBSTITUTE PIN
Carton steel doors or bars on the Windows to the concrete or brick walls specialists usually fastened with sharp pins. If you need to remove the box, the case is difficult to pull the...
FOR WELDING, START-UP AND CHARGING
For more than ten years, using a homemade device proved during welding, cutting metal sheets with thickness from 0.6 to 12 mm, the power at the time of starting the engine of a motor...
