Usually designers avoid threaded joints if at the conventional “nut” less than two to three threads. Method shown in figure, allows you to make a threaded connection more reliable. However, to make a hood, will have to make a simple punch and die.
Recommend to read
LEGO CAR TO DRIVE AROUND
Australian Steve Sammartino (Steve Sammartino) and Raul Romanians Aida (Raul Oaida) presented the car on the pneumatic actuator, assembled from parts designer LEGO. The car accommodates...
MILL INSTEAD OF THE PLOW
The tillers, was developed by Genrikh Alekseevich Kuznetsov from Moscow, is different from many homemade designs use instead of the plow cutters. Turning to the work shaft at the same...
