Over time, knives to the grinder are worn down and there comes a point when its working elements a gap. To eliminate his nevinovna end of the nut is no longer possible. The result is grind products are not cut, crumple, CA recycling CIP spent two to three times more. To choose this gap is easy with the washer or ring of suitable size, which should be worn on the trunnion of the feed auger from the handle.
V. SHEPELEV, Ordzhonikidze
Recommend to read
WITH THE “METEOR” LYRICS
High-speed cord model presented on these pages, designed and manufactured in the older group of avtomodelistov club for young technicians Novosibirsk plant named after V. P. Chkalov. A...
BATH BRICK
When performing masonry for good adhesion of the bricks with a solution good the contact surface of the pre - "primed"—to immerse at least for a few seconds in the previously prepared...
