THE HOUSE WILL BE WARMER

THE HOUSE WILL BE WARMERTwenty years I live in a house built once with their hands. Of course, then was folded up and the furnace, which three years later was covered with ceramic tiles with dimensions of 200X200 mm. And for seventeen years the veneer is quite securely held on the surface of the furnace. Moreover, in my life I had to decorate ceramic tiles hundreds of furnaces, and the tile itself random, different quality and format, but none of the owners never complained of facing: tile, Bouncing off the furnace even in those places where there is maximum surface temperature — in the region of the furnace.

We strongly recommend to do this for those who have not finished in my oven. Besides the fact that it takes the attractive and elegant appearance, it gets clearly warmer: baking in the lining holds heat longer, and it’s almost a third reduces the required amount of fuel.
Oven
 
The technological process of veneer is not too complicated to do it will of any person who at least once was holding a spatula and a hammer.
 
About the technique of such work will illustrate the widespread furnace, consisting of two plates and two ovens.
 
First of all, removed plaster and exposed brick walls. Then the furnace is mounted the valve — it is a boarded up between the bricks pins (shortened to 60 mm nails with an initial length of 100 mm, sharpened the needle on a plot of 20 mm), soft steel braided wire with a thickness of 1 mm so as to form a kind of mesh.
 
Next, the prepared solution. It will require cement grade 500 (1 part), sand (1 part) and salt. After mortar mixing cement, sand and water — it is introduced podarennaya salt at the rate of 1 kg per bucket of mortar. The consistency must be like thick sour cream.
 
The prepared mortar is applied on the back side of the tile so as to form a kind of pyramid, after which the tile is pressed against the surface of the stove with the expectation that the thickness of the mortar layer between the tile and the brick was 15…20 mm.
Technological work.
 
In the process, inevitably there is the problem of cutting tiles. You can do this in a regular glass cutter with subsequent fine-tuning on elektrotochilo during the rotation of the abrasive disk with a frequency of 4500…5000 1/min. also Note that tile designed for lining shall be thoroughly soaked in water and soak in it in the process.
 
V. PASIKOV, farm between kovylkin, Rostovskaya obl.

Recommend to read

  • “TUESOK” FOR FIVE MINUTES“TUESOK” FOR FIVE MINUTES
    Collect fruits in a basket or basket, of course, convenient, But what if only a cardboard box or a box made of thin material plates? The output tells the picture. Steel wire lignite grip...
  • BIKE WIDE PROFILEBIKE WIDE PROFILE
    In the summer the motorcycle "Minsk" served me faithfully, like the fairytale the little humpbacked horse. In autumn and winter, due to the off-road, it idled, though the need for...