THE SEAT TO THE BATH

If the family is elderly or disabled, they are for convenience (and perhaps facilitate) the adoption of water treatments will not prevent a simple seat on the sides of the bath. The seat can be made of ordinary planks of hardwood with a minimum thickness of 25 mm, a width of 200 mm and a length — greatest width of the bath. That seat came off the boards to him from the bottom, closer to the front edge, is attached to the longitudinal edge emphasis is made of the same boards that seat (but narrower and thinner).

The ends of the ribs are cut on the inner profile of the sides of the bath with a slight clearance. If such an edge to do and on the other side of the Board, the seat will be a “Changeling”, that is, it will always be in position.

Seat:

1 —regiment (Board s25…30); 2 — edge-emphasis (Board s15…25); 3 — edge-back (Board s15—25)

Special attention should be paid to the finishing of the product: round corners and edges, carefully sanded the surface so that they were “without a hitch, without a hitch”. Painting is optional, but after the water treatment, to avoid the appearance of mold, it is necessary to dry the seat. If such prevention is not satisfied, then you can make and coverage. It should only be water resistant, especially the ends.

At other times the seat may serve as a shelf for toilet articles (soap, shampoo, etc.).

A. POLIBIN