Good recommendations

As you know, recruitment groveley supplied gotowanie, limitations and quickly running out. Commercially available is the “Blueprint” and slate pencils from pencils do not fit the diameter. They have to grind off sandpaper or a blade, which is quite unpleasant and messy procedure. Insert the clip Sirius cut collet pencil: now you can use any Read more…

Paint the trim and window frame with the outside of the house, “not touching” to them, not to break and the glass can if are stairs with special emphasis – the horizontal bar attached at its ends supports (e.g. wooden “washers or churbachki).

The rain is not afraid of the baby, if you make a “windshield” for his stroller. You will need two separable zippers and a piece of plastic film. Design is clear from the picture.   A. HUDIK, Yoshkar-Ola

This files most often prescribed magazines sutured, piercing a few hole and tie them with lace. Offer a more simple method, take two identical slats on the size of the log the drilled holes and between strips by placing a stack of magazines subtended by the ends of the screws.   S. NAZARE, G. 3лынка, Read more…

During chemical processing of photographic plates and papers usually use medical tweezers (it can be purchased in the pharmacy). However, the notch in the jaws often damage the emulsion layer. To prevent this put in the jaws of the tweezers p polihlorvinilovuju tube with a diameter of 2-3 mm. pre-softened in acetone. After drying, the Read more…

Pollinate the plants IPI to paint a surface using a spray gun. However, instead of the regular “pear” connect foot pump-“frog” — the efficiency will increase several times.

Another use of old tires in the suburban area recommends that the Bulgarian magazine “Put yourself” as “Parking” of bicycles near the house.

It often happens that a brand new, recently purchased, pasatizhi, pliers, wire cutters, etc. can neither open nor close. The easiest way to prepare the instrument for operation with abrasive powder (waste ocilogon stone, fine sand, etc.) For this these pliers it is necessary to moisten and sprinkle with abrasive. Twenty to thirty movements and Read more…