Good recommendations

Experienced motorists know that most of the canisters becomes defective, usually due to rubbing of corners and bottom of the pavement or during transport in the “Laden”. To exclude this undesirable phenomenon, I propose to gird capacity two rubber rings scraps of the old hose. Joints are made with wire.

To pull the oars will be much easier if you install in a boat footrest. It consists of two shaped holders and crossbar. As the crossbar, you can use the cut water pipe.

Sometimes in fishing there is a need to put the bait, take the bait, Sneath from the fire pot with the finished soup, and the hand is not even an ordinary slingshot. To get rid of this inconvenience, equip a fishing rod two folding legs, which in the transport position, is pressed against the rod Read more…

For applying glue on the floor during the laying of linoleum can be done in just a few minutes from fanerki thickness 3…5 mm, cut it “comb”. Work will be more convenient, if the scraper to impose on the MOP handle.

Gently dry the freshly painted item is not so easy. Even more complicated task if the product is painted on all sides. A good yield could be hanging it in the antigravity field, but this is not yet opened. I suggest that instead of anti-gravity field to use… the usual pushpin. Covered with enamel on Read more…

If there is no suitable photo frame it can be replaced by any opaque tape, stretched on the table of a photographic enlarger in the longitudinal and transverse directions. The ends of tape segments need to pull the rubber band. And DEBATIN, Engels

Varnish or paint the chair — this seemingly simple task often ends stained priest, FDI it is necessary to proceed in stages. Four small cloves, hammered the bottom of the legs, eliminate all difficulties.

A lot of trouble delivers the movement of the machine along the surface of the workbench during operation. This can get rid of the crafting for each stanochek stand with four spikes, and the bench, drilled the appropriate holes.