The construction of the cellars starts with the Foundation. To do this, the perimeter of digging a trench with a depth of 30— 40 cm and a width of 70-80 cm On the outer side of the trenches set the plate of foam with a height of 30-40 cm If only packing foam, its pre-wrapped with roofing material. Installing such plates are pursuing two goals: prevent the freezing floor of the cellar in the winter and penetration of rodents. After the installation of the insulation trench is filled with sand to 10-15 cm above ground level. Then, on the surface, a few larger cellars, on the sand put a waterproofing from two or three layers of plastic film or roofing material. Top waterproofing is also filled with sand and a surface level.
CELLAR HEATED
The soldering iron is any homebrew. But those who have to deal with modern electro – and radio equipment, this tool is something special. And the requirements for it are quite hard: with small size, low supply voltage and low power consumption to ensure the excellent quality of soldering. And with the maximum comfort, including temperature controller soldering tip and a stand with a tray under flux solder and tinning.
Those who live near the water, the boat is as necessary as for other bike or car. Of course, experienced shipbuilders-fans are unlikely to descend to the boat, we want to bring to your attention, but for beginners shipbuilders design of this boat is what you need. It is simple, technological, besides allows on the basis of one case to build a row boat, and a sailboat.Before you start building housing on a large sheet of plywood it is necessary to draw Plaz — at least, to portray the theoretical section of the housing.
In the practice of the rally often faced with the necessity of soldering or welding. A few years ago I accidentally saw used for this purpose, benzopyrene production of the GDR, then had the idea to do the same, but running on gas. The result exceeded all expectations — and now gas-heated soldering iron is a decent place to set my tools. Exploitation it during body repairs, radiators, bits of copper cables with large cross sections confirmed the efficiency of the design. The main advantages before traditional “hammer” and a blowtorch are: the possibility of continuous soldering, the temperature setpoint, which is important when performing large volume of work, as well as the possibility of regulating the degree of heating.