The magazine has repeatedly printed design microvesicles on the basis of details of children’s bikes and motors D-5 and D-6, however mainly for use in the summer. We with the friend decided to create a machine where you could go in summer and winter.
Paper tape glued to the joint between the door frame and the wall, protects the knot from cracking and shedding of plaster. Better to glue or PVA Bustilat. D. ZVEGINTSEV
Tanks for water, as almost all gardeners are very uncomfortable to carry. But if this capacity is the side of the handle, a good helper will be a trolley made of planks and any wheels from children’s bikes or strollers. Tank is suspended on a hook over one of the handles. In this position it Read more…
If you need a clamp of a certain size, it can be made from what is at hand: steel rod, strip, angle or profile. Making them need the bracket, drill holes in it and threaded (or welded nut) under the clamping bolt and the tool is ready.
In improvised furniture experience the greatest difficulties when sealing the ends, especially chipboard. I hang the ends of the veneer. On cut to size a strip of veneer put in a thin layer of PVA glue and giving it a little dry, apply a strip of detail. Then slowly iron the veneer with a hot Read more…
I want to share the experience of producing a fairly simple tracks for motionart. Many fans of the design familiar to the complexity of this node. It is much easier if the basis to take any roller chain. For example, I used motorcycle. No additional reinforcements are not required: margin of safety it proved sufficient for the new scope.
It is easy and convenient to clean the floor in the Studio or room with any ordinary MOP, the “dressed” Terry cloth Velcro.
I have improved the conventional electric soldering iron. It turned out lightweight and compact (see Fig.), you can carry even in your pocket. It is easy to make and a beginning radio Amateur. This requires electroputere, a burned out tube and cut stranded insulated wire. From the bulb the bulbs carefully pry off the cap Read more…
Everyone had to solder, know how much trouble is due to the fact to hold the workpiece in position. Much easier to work with if you make a simple vise, consisting of several pegs mounted on a wooden bar.
In the manufacture of hull racks for back walls typically use fibreboard sheets (MDF, or, as they are frequently called, – hardboard). For transportation of wide sheets are cut, providing the kit for subsequent docking of the special H-shaped plastic profiles. But the edges of the sheets of them during installation constantly popping up. Pomaia Read more…
