…can be made from scrap pipe of appropriate diameter. The case will protect the working part of the tool during storage. S. CHIRIKOV, Tallinn
Most automatic screw machines have trehkanatnoy the self-centering, which is easy to fix the workpiece cylindrical or hexagonal shape. And if it is of square section! In this case, a simple fixture, which is a clamp bushing of soft metal cylinder with a flange in the center of which done square hole and side — Read more…
All probably know what a kicksled. Very comfortable design, but it was too heavy and bulky. Once the IIA came up with the idea: is it possible to lighten them and make them leaner? It turned out. For this it is necessary to leave only one snake. As the audit showed, these sledges it is possible to ride even a Threesome.
When drilling holes in the ceiling sawdust get in your eyes, that interfere. To avoid this, put the drill bit on the cap of the cream or shampoo.
The magazine has repeatedly printed design microvesicles on the basis of details of children’s bikes and motors D-5 and D-6, however mainly for use in the summer. We with the friend decided to create a machine where you could go in summer and winter.
Paper tape glued to the joint between the door frame and the wall, protects the knot from cracking and shedding of plaster. Better to glue or PVA Bustilat. D. ZVEGINTSEV
Tanks for water, as almost all gardeners are very uncomfortable to carry. But if this capacity is the side of the handle, a good helper will be a trolley made of planks and any wheels from children’s bikes or strollers. Tank is suspended on a hook over one of the handles. In this position it Read more…
If you need a clamp of a certain size, it can be made from what is at hand: steel rod, strip, angle or profile. Making them need the bracket, drill holes in it and threaded (or welded nut) under the clamping bolt and the tool is ready.
In improvised furniture experience the greatest difficulties when sealing the ends, especially chipboard. I hang the ends of the veneer. On cut to size a strip of veneer put in a thin layer of PVA glue and giving it a little dry, apply a strip of detail. Then slowly iron the veneer with a hot Read more…
I want to share the experience of producing a fairly simple tracks for motionart. Many fans of the design familiar to the complexity of this node. It is much easier if the basis to take any roller chain. For example, I used motorcycle. No additional reinforcements are not required: margin of safety it proved sufficient for the new scope.