The design of the rear cover of the engine KMD-2,5-made, in our opinion, wrong. The flow of fresh fuel mixture from the distribution node goes directly to the bypass channels of the cylinder, bypassing the area of the crankshaft. And the result is the most loaded part of the Microdrive (neck crank and lower rod cap) remains without grease that enters the motor along with the fuel-air mixture from the carburetor. Responsible node is overheating due to strain fall resource and capacity.
NO MATTER WHAT TROUBLES
Gas stove is a source of danger in the apartment and demands to the Saba special attention. Offered under the handles of the valves of the burners to put red stripes visible only in the “open” position. Now only one bigpage glance at the stove to see if the gas is blocked.
The proposed design (it can be called a two-storey stool, stool-ladder) is very practical, simple to manufacture and may find use in the summer house and in the apartment.
Wood sheathing. Such way of furnish of walls in recent years is becoming more common. The most preferred veneer tongue-and-groove boards. On brick or concrete walls, they are normally attached to the wooden planks. The most appropriate the cross-bar 25X40 mm. to Mount them to the walls of the most reliable with the help of plastic dowels and screws. Particular care should be fixed to support bars in the areas of the corners of the walls. The distance between the bars depends on the thickness of boards: plating thickness 10 mm are typically used to cover walls for supporting bars, spaced at 400-600 mm. Sheathing of boards of greater thickness (12 mm) recommended for surfaces separate elements and must be sufficiently rigid when the distance between the supporting bars of 500-600 mm.