It has long been observed that the water surface effect on people calming. It is very valuable in our troubled time, when the human nervous system is subjected to constant emotional tension and stress. That’s why nice to countryside passing near any body of water. If there is no nearby natural, it is possible to construct an artificial, albeit small, but directly on the garden or summer cottage. Moreover, there is an option that does not require special materials and cost and available in the production of almost everyone.
BUILD… THE LAKE!
The list of Moto – and electrophotonics that use rural residents, is growing steadily. Along with tractors, tillers, mills, kartoffelschalen, mower they have different fixtures, which they say: IU-lotovka, but the farm will fit. About such seemingly small, but undoubtedly useful devices in our factsheet.
In country furnishing commonly used A-shaped (in profile) folding chairs: they are comfortable, reliable, easy to carry. But for a full set of them requires the same folding table. We offer German magazine “Cultures und Heim” table could not be better coordinated with these chairs: it is also foldable, is based on the two sliding supports, which consist of a framework of connected card loops. Frames are knocked together or are assembled from wooden planks with cross section of 50×25 mm.
The construction of the cellars starts with the Foundation. To do this, the perimeter of digging a trench with a depth of 30— 40 cm and a width of 70-80 cm On the outer side of the trenches set the plate of foam with a height of 30-40 cm If only packing foam, its pre-wrapped with roofing material. Installing such plates are pursuing two goals: prevent the freezing floor of the cellar in the winter and penetration of rodents. After the installation of the insulation trench is filled with sand to 10-15 cm above ground level. Then, on the surface, a few larger cellars, on the sand put a waterproofing from two or three layers of plastic film or roofing material. Top waterproofing is also filled with sand and a surface level.
The soldering iron is any homebrew. But those who have to deal with modern electro – and radio equipment, this tool is something special. And the requirements for it are quite hard: with small size, low supply voltage and low power consumption to ensure the excellent quality of soldering. And with the maximum comfort, including temperature controller soldering tip and a stand with a tray under flux solder and tinning.
