Advice

To save yourself from cleaning when drilling holes in the wall, you need to bring the drill pipe is included vacuum cleaner — not a speck of dust on the floor will not fall!   R. ARAKELOV, Chelyabinsk

When installing lighting outdoors, in the garage, in the cellar of the desired closed fixtures. Such a lamp you can do yourself in minutes. This will require any holder and glass jar 850 g with a screw cap. Cut a hole in the lid for the threaded top of the cartridge, put the cartridge with Read more…

Light shirts and blouses ill stay on regular hangers, especially plastic: slide, warp and this crumple. There is a simple solution to this: you need with the help of glue “Moment” to attach at the ends of the pieces of sponge rubber or foam rubber, as shown in the figure, and hangers will keep even Read more…

To increase the useful volume of the cupboard can homemade extra shelf, shown in the figure.

Plastic film Yes simple arc of wire or branches is here and ready temporary mini-greenhouse over the bed, covering the plant from spring vagaries of the weather. However, protecting from frosts, it is a kind of umbrella, depriving planting is desirable for germination of rainwater. But to slip on the sides of the greenhouse cut Read more…

When the pencil lines of the drawing or drawing close to each other — the usual eraser, it is difficult to remove the erroneous one so as not to damage the adjacent correct. But this operation will be virtually the exact jewelry and if a thin slice of gum to hold in the “beak” of Read more…

In the proposed padded insoles for shoes is nothing new, but… To the insole not “went” the shoes, cut they have a few larger native insoles with the edge at an angle of approximately 60°. As a result, the insole rises “at his disposal” and at the same time forms a rounded edge that prevents Read more…

Usually, to make a loop on the wire to connect to the switch or outlet that electricians use pliers. Two pins Ø 4 mm, installed in front of the handle of a screwdriver, can successfully replace them.

The end of the stick in the hole of the butt is held by the wedge. But eventually, the knot loosened and then the axe is to work not only uncomfortable,but dangerous. If time and opportunity “to peremeschenii” ax no, do at least a simple temporary “ersatz”-mount – tighten a few screws with the so-called Read more…

Virtually any stop can be turned into a joiner’s workbench, if you use a removable focus of clamps and riveted to her “comb” of steel band (for example, saws).