Advice

In any workshop is the most convenient way tool storage — placing them on a wall stand: and immediately visible, and easily accessible. However, returning after use, is easily confused on which bracket is which tool was. This does not happen, if on the stand to put paint the shadow outline of each of the Read more…

Offer to store small bolts, screws, nails, nuts and washers, and any other such trifle — cell cardboard or plastic container from under the eggs.   V. GOLOVASHIN, Rybnoe, Ryazan region.

A five-liter cylinders for portable gas stoves are easy to use, but to exchange them for sometimes full and not empty. The fact that the wear of the valve stem from the old container for the consumption of the gas disrupts the gearbox. To restore the flow of gas through gaskets is a difficult and Read more…

Developed a lot of tools for punching large diameter holes in sheets of plywood; many of them are rather complicated or cumbersome. I need only a wooden plank to two nails. Hammer them into the tank so that one became the axis of rotation, and the other is a kind of cutter protruding from the Read more…

For pumping nipple balls often use Bicycle pump with a special needle. But it does not matter if it broke or its just not there at hand: with this work well covered by a normal Bicycle nipple off a rubber tube mounted with its threaded shank in the hole of the pump.

To score a long thin nail, and especially copper or brass (e.g., with mounting frames) is always a problem. Will help you in this case, the conventional pliers or a wooden clothespin.

To withstand the strictly perpendicular direction when drilling holes in the wall or to any vertical surface— just attach to a drill with tape or duct tape carpenter’s level. His shifty air bubble in a glass tube, show that you have not rejected the tool from the horizontal.

Produced digital multimeters (like many other devices) have on the arrow switch in color that almost merges with the body. Arrow will be more visible, if you paint with white enamel or stick to it with glue “Moment” the same size arrow out of paper or thin white plastic.

When installing the propeller on the crankshaft of the engine of the snowmobile of space to accommodate the exhaust pipes and mufflers. And without the exhaust system of a two-stroke engine is not only more noise, but also consumes more fuel. However, its substitute a simple engine-IZH can serve steel cups Ø 45 mm and Read more…