Advice

Convenient storage of small tools is not only about safety and effectiveness. I think that drills, taps, needles, and other small tool is best stored upright in a plate of thick rubber. Perforations drilled or punched with a sharpened pipe, and their diameters must be smaller than the diameters of the installed items by 30 Read more…

If the rune was not polishing — no problem! With the processing of small surfaces perfectly cope conventional tube driven in rotation by microdrill. To secure the tool cartridge in probnu 3/4 of its length you should install the screw and then cut off his head. Before polishing the tube should be rubbed with the Read more…

Chips, widely used in the electronics industry, are increasingly used in Amateur practice. However, when itike them in charge or replacement from the wizard, you need increased accuracy, and loyal companion of tweezers, it turns out it is not enough convenient: along case the ICJ did not seize, but backwards can damage the contacts. Here Read more…

A thin drawing pen tool is fragile, and inserted in a normal pen, easily spoiled by careless storage. Better to use it with the handle, and with a collet Chuck: and is held securely, and, turning, to store this safely.

how it works like this, and a good host you will not regret the five minutes to produce such a device. At the depot you can put any thick-walled bottle. You will also need the rubber tube and a metal or glass tube of length 10— 12 cm and an inner diameter of about 3 Read more…

Recently I had to solve an unexpected problem: how to hang “long” picture so that nothing showed outside, and fastening is reliable? Normal version with one nail did not fit hard to adjust the horizontal position of the frame; with two, it’s easier to do, but the desire for “stealth” suspension does not give jelaemoe Read more…

Usually to reinforce the cabinets on the stack, we Drill the horizontal holes, but if the plug is weak or loose fasteners, close to trouble: with the increase of the load the shelf can collapse. I drilled holes at an upward angle; in the furniture, and vertical panels, but down. It turns out a very Read more…

The range of action of conventional clamps is significantly expanded, if the emphasis is extensible, as the wrench. It is done so. In an l-shaped bracket drilled and cut the hole for the clamping screw, and in its longest part — the holes for mounting the movable jaw. It is fixed with a pin or Read more…

To shorten a long bolt or stud, such a task is not so rare encounter tinkerers. In order not to damage the grip of the thread, I suggest to use a simple tool, which is a metal strip 5-10 mm performed in her screw holes from M3 to M16. Now with the help of a Read more…