Hams, self-repairing computers and modern means of automation or manufacturing such equipment, are faced sometimes with the need to record information in the chip programmable logical matrices (PLM). With similar problems they have, for example, to meet when you combine the joystick with the keyboard on the basis of MC КР556РТ1 (КР556РТ2). However, it may be that the existing programmer (even among the so-called universal) are not designed for firmware of these chips. To buy new, more specialized and costly electronic device is not always justified. Another thing is to modify what is already at hand.PROGRAMMATOR FOR CHIPS
Hams, self-repairing computers and modern means of automation or manufacturing such equipment, are faced sometimes with the need to record information in the chip programmable logical matrices (PLM). With similar problems they have, for example, to meet when you combine the joystick with the keyboard on the basis of MC КР556РТ1 (КР556РТ2). However, it may be that the existing programmer (even among the so-called universal) are not designed for firmware of these chips. To buy new, more specialized and costly electronic device is not always justified. Another thing is to modify what is already at hand.
I am convinced that any device with power supply-battery flashlight will only benefit if you provide it a makeshift terminals, providing reliable electrical contact in the connection to the battery. Moreover, the time and cost it takes a bit.
The principle of operation of my proposed homemade svetvincenat “Whelan” is forced Ventilation of the Lamp bulb and heat the bottom of the room with warm air by sending heat to the floor, which is the “waste” of the light source. Moreover, the “Whelan” cleans the air from dust. And the lifespan of the lamp filament is thus significantly increased.
Fluorescent lighting is much more economical and durable than conventional incandescent lamps. Especially when equipped with modern fluorescent lamps (LDS) with a cap, which fits easily into familiar to all electroputere, and a tubular helical radiator, not exceeding in size the usual tube stellabelle.
In the old days, when required to perform switching in the electric circuits when the voltage rises to a certain threshold, resorted to the use of polarized electromagnetic relay. However, the substantial size and weight, lack of reliability of the kinematics and contact pairs severely limited the use of these devices. Now in their place came a miniature non-contact thingies called discs. This four-layer semiconductor diodes whose structure is like a two transistor: p-n-p and n-p-n type, with the base of one is connected to the collector of the second, forming the internal positive feedback (Fig. 1).
“For the treatment of infield has decided to replace the tiller internal combustion engine electric. Already got polutoraterabaytny the motor. But it is three phase. How to connect to the network, where only one phase and “my best”?
Viewers living in areas of new buildings high-rise buildings and besides, near the television station, I recommend to get a homemade antenna-loop. It works reliably even when the so-called “strong reflections” television signals and preventing screen ghosting of the image.
Who used a portable transistor radio, know how, over time, decrease the sensitivity and loudness of the radio, begins to “float” the rate of advance of the tape in the music player…
Electricity is steadily going up. So now even avid spenders are forced to take care of her savings, the benefit — there is a very wide selection of devices designed to save valuable kilowatt hours. Its rightful place is here and homemade machines off “extra” loads. It is gratifying that among the most interesting of them — the development receiving a “ticket to life” in the pages of “Modeller-designer” (see, for example, publications in № 4’89, 6’91, 9’92, 1’95, 7’2001 of the journal).