There are many ways to use two-handed saw one person. I turned it with that purpose in cutter. Cut of a saw, the ends with handles, and instead have attached a saw blade. New pen — team, picked up three plywood blanks: the outer is of thick plywood (from the Board), and cropped mid — Read more…
When my dad collected a wardrobe, had to tighten a lot of screws. We remember posted in the “Modeller-designer”, the Council is to use in such operations as rotation. But we had the drill. What if you try it? Took a screwdriver from a set of novosela, secured in the Chuck of a drill — Read more…
Many people know how uncomfortable to use stationery glue of the modern bubbles with a brush — the plastic spout with a spatula. The contents of it then squeezed a puddle, all is not. Meanwhile, will help a simple paper clip. Insert it halfway or a little more in the slot of the spout of Read more…
I am an old gardener, many years of perfecting his greenhouse. First staged in her warm bed: dug two-foot holes in the ground, put in it a layer of twigs, stems, and covered with earth, rammed. On top of sketched leaves and waste paper, a little of the soil in which earthworms let loose, and Read more…
The familiar metal lids from bottles will serve no worse than the famous springy washers. Grover thanks to its ribbed “skirt” that will prevent accidental removing of the screws in the joints of any parts subject to vibration.
Even with natural bristles, although synthetic toothbrushes are updated by us frequently. But the various wall holders with holes for them to live long and do not always correspond to the cross section of the handles of the brushes. However, many of the handles on the end there is a hole. If you adapt them, Read more…
When installing water pipes plumbing is usually seal the threaded joints with oakum, hemp or heavy-bodied paint. In recent time there appeared a lot of sealants and seals of the film, however, not always this “chemistry” is at hand, In such cases, you will come to the rescue… the usual chewing gum — or rather, Read more…
Screws with Phillips very convenient during Assembly, but if there is a need for dismantling, their removal, especially if the head was under the paint, is difficult. Most often when you try to loosen the screw slot is cut, and has no screwdriver can not take it. In such cases, I use the drill: rassverlivajut Read more…
For the case when screw cap cans, as they say, stuck and does not open, use a simple device made of a wooden block and the old lap belt. Guides buckle do not necessarily, but to nail the strap to the bar, and on the other side to drive the pin under the belt holes Read more…
Health, unfortunately, sometimes let people down, and they get sick, often for long periods of time. In such periods of life, they need not only assistance, but also in various devices. One of the fixtures had to come up for bed-patient: it took the bag, and improvised. Managed To make it from plastic bottles of Read more…
